Next I began messing about with applying pressure above the disc drive with my hand (squeezing the front and back together) as I inserted the disc as some people suggested knocking on the console. Secondly I tried forcing my pro to update in safety mode to rebuild the database as I heard that could help, but again it didn’t. First I tried completely dismantling my pro to get to and clean the disc drive lens, but it already looked pretty clean and that didn’t make a difference. After this I’d get a pop up saying unrecognised disc. I had a problem where when I put any disc in it would chug a bit then sound like the disc was being relocated then chug a bit more.
That should be it! If it doesn't work you can try to adjust the servo that regulates voltage to the lasers instead but that could fry the lasers out reducing the PS4 to junk! Good Luck! The first thing is to open the PS4 up and blow it out with air from a Air Compressor to reduce the dust, heat, static electricity that dances all over the place because of the dust! Not only does the dust contribute to the items I just wrote above but it also causes tiny electric arcs if there is to much dust on the circuit board too! Remember to first blast the inside with air from a Air Compressor then clean the lenses with an eraser gently, then use alcohol on a Q-tip on both the lenses and metal contacts and blow it all out "again with air" from a Air Compressor! The air from the compressor should dry the 90% or 91% alcohol so that there will be no shorts. Both need to be cleaned by an eraser and then by a Q-tip with 91% alcohol. The Laser of the Blu-ray has actually two lenses/lasers/LED's.
0 kommentar(er)
